(racoon 953) Re: IKE2 IPSEC Tunnel Mode using Racoon2

Hi,

At Thu, 27 Jul 2006 15:55:18 -0400,
"Glenn Bronson" <[email protected]> wrote:
> 
> Has anyone successfully run the KAME for racoon2 IKE2 in tunnel mode?
> All the samples are racoon2.conf  transport mode, and I have to admit
> that I'm baffled when converting it to tunnel mode.
> 
> policy {
>                 ipsec_mode tunnel;
>                 ipsec_level unique; # Not Yet Implemented, always
> 'require' 
>         };
>  
> selector 32 {
>         direction inbound;
>         dst 172.112.1.1;
>         src 172.134.1.1;

You can write "dst 172.112.1.1/24" and so on.

>         upper_layer_protocol "any";
>         policy_index tunnel1;
> };

It seems that you trimmed your config file so I'm not sure,
but do you have (another) corresponding selector for "direction
outbound"?

> 
> policy tunnel1 {
>         action auto_ipsec;
>         remote_index tunnel1;
>         ipsec_mode tunnel;
>         ipsec_index { ipsec_esp; };
>         ipsec_level unique;

ipsec_level should be "require" for now.
I'm afraid that "unique" doesn't (yet) work here.

>         peers_sa_ipaddr 10.110.112.1;
>         my_sa_ipaddr 10.110.134.1;
> };


p.s.  All active developers of racoon2 are now
[email protected], so it is better to ask there.
And could you post the whole config file and iked's log next time?


Thank you for trying racoon2,
-- 
KAMADA Ken'ichi <[email protected]>