Re: implemented a new beep_hide_targets setting

I'd like to do that when I clean it up a bit. One thing I'd like to do
is have it auto-recognize when its settings have changed and then reload
them. I tried catching the signal "setup changed" but it doesn't send
any parameters. I guess I could take over the "set" command but the
changes wouldn't be in place until after my handler was called (right?).

The other thing to do would be re-initialize each time any setting is
changed, but that doesn't seem right either.

Mike

On Thu, Mar 25, 2004 at 08:21:28PM +0100, Geert Hauwaerts wrote:
> On Thu, 2004-03-25 at 20:18, Mike Weisenborn wrote:
> 
> > > > Is there interest in this, and if so, how should I proceed in submitting
> > > > this?
> 
> You might want to submit it to [email protected]
> 
> Regards,
> Geert Hauwaerts.
> 
> -- 
> .---------------------------------------------------------------------------.
> | Geert Hauwaerts          http://www.safeweb.be         <[email protected]> |
> | Certified Unix/Linux Administrator  ||  Cisco Certified Network Associate |
> `---------------------------------------------------------------------------'
> 
> 

-- 
Mike Weisenborn, Senior Partner
[email protected] 770-886-0443 www.clearbuilt.com

Clearbuilt Technologies - consulting, development and education
for the real estate and construction industries