Re: Main window position
"George L. Yermulnik" <[email protected]> Thu, 22 Dec 2011 11:49:58 +0200
| Newsgroups | gmane.network.licq.general |
|---|---|
| Message-ID | <[email protected]> |
Hello! On Wed, 21 Dec 2011 at 19:37:29 (+0100), Anders Olofsson wrote: > > If it's not too bad-mannered, I'd like to ask you to take a look at > > another issue I have here on my sendbox. It's not a fault or something > > like that, but is very annoying: after upgrading from 1.3.x to 1.5.x > > each time I open the main contact list window from a systray it goes up > > vertically for exactly half a centimeter. Maybe it's not because of any > > Licq components. So I'm just asking for your opinion =) > Did you use Qt4-Gui with 1.3.x so you can tell if the problem appeared > with the new Licq version and not the switch to Qt4? I can't recall which Qt version I had been using before upgrading to 1.5.x =( That happened along with installing my new workstation from scratch. But I surely remember that this behaviour appeared exactly after upgrading to 1.5.0. > Which window manager are you using? Enlightenment (E16) 1.0.10 > Does it happen if you just minimize and restore it normally to the taskbar? Nope, it doesn't. It happens only when left-clicking on Licq tray icon to show/hide main window. I've noticed another "side effect": with main window opened first tray icon click sets window to sticky state and only the second click hides the window. Log message is: <timestamp> [INF] qt4 gui: Setting Sticky state of window 0x28000ca to true It's not that critical and I almost got used to this behavior. So If I'm the only one reporting such a "bug", guess it doesn't worth your attention as it might be because of some misconfiguration of my WM or anything like that =) > > And a feature request =) Is it possible to add possibility to toggle > > main contact list window state (open/close) via licq_fifo? > That should be possible. I'll have a look at it and see what I can do. Thanx a lot =) And one more "feature" request =) Can you please add "//IGNORE" for `tocode' of iconv_open() in src/licq-osd.cpp ? It should make iconv silently discard unconvertable chars instead of failing itself at all. > /Anders -- George L. Yermulnik [YZ-RIPE]