Erroneous results acquired

Hi, 

 

I wonder if any of you guys can help with a problem that I have? I wish
to acquire data of utilization on Gig E interfaces on a Cisco 7200. I
use the OID's ifInOctets and ifOutOctets in my config file reading the
32bit counters. The graphs produced seem to be displaying incorrect
results. I am comparing my results to that acquired by cricket. I'm sure
that my syntax is correct. See syntax below for interface 149.

 

Target[<name>]: ifInOctets.149&ifOutOctets.149:<communitystring>@<device
IP> 

 

Another problem I found is that I cannot get any data usung 64bit
counter OID's, ie. ifHCInOctets and ifHCOutOctets.

 

Thanks, 

Faiqo

 


Please note: This email and its content are subject to the disclaimer as displayed at the following link http://www.is.co.za/legal/E-mail+Confidentiality+Notice+and+Disclaimer.htm. Should you not have Web access, send a mail to [email protected] and a copy will be emailed to you.

_______________________________________________
mrtg-developers mailing list
[email protected]
https://lists.oetiker.ch/cgi-bin/listinfo/mrtg-developers