Re: more than in & out values
Steve Shipway <[email protected]>
| Newsgroups | gmane.network.mrtg.user |
|---|---|
| Message-ID | <7294716191A1E142B80615ED2C633BCA010E38E3@uxcn10-2.UoA.auckland.ac.nz> |
When using MRTG with RRD, you are restricted to two (and exactly two) datasources. This is a restriction of MRTG, not of RRDTool, so you could manually create an RRD with additional datasources - however, MRTG would not update or read them. If you are using the Routers2 frontend for MRTG/RRD, then you can have multiples Targets, each with two datasources, and then define a Userdefined graph over them to make a single graph with more than 2 variables. The component targets can be hidden from the menu. See the examples for Linux server CPU and network device 'Incoming' graphs at http://www.steveshipway.org/cgi-bin/routers2.pl Steve Steve Shipway University of Auckland ITS UNIX Systems Design Lead [email protected]<mailto:[email protected]> Ph: +64 9 373 7599 ext 86487 ________________________________ From: [email protected] [[email protected]] on behalf of Engrie, Marc [[email protected]] Sent: Wednesday, 29 February 2012 4:03 a.m. To: [email protected] Subject: [mrtg] more than in & out values Hello, Is there a way (simple or complex) to get more than just 2 values (in & out) into a RRD file using MRTG? If yes please advise on how to Kind Regards Marc Engrie ICT Infrastructure Manager Tel: +32 2 776 21 63 GSM: +32 476 52 35 45 _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg