Re: Hilfe

Create a configuration file for MRTG using cfgmaker.  You can use pretty
much the same method to monitor any SNMP switch or router, not just Cisco.
Here is an example using some general options:

 

cfgmaker --ifdesc=catname,ppname,descr,alias,ip,name,nr --ifref=ip,name,nr
--global='WorkDir: /var/rrdtool' --global='LogFormat: rrdtool'
--global='Options[_]: bits,growright' --show-op-down --output=device.cfg
--snmp-options=:::::2  --community=community   device

 

 

Replace 'community' and 'device' as appropriate.  This will omit interfaces
with a speed of zero or that are administratively down; you can add
'--no-down' if you want to graph these anyway.

 

You can find more information in the cfgmaker documentation; unfortunately
for you it is in English.  I don't know if there is a German translation
available anywhere.

 

Steve

 

 

 

  _____  

Steve Shipway

ITS Unix Services Design Lead

University of Auckland, New Zealand

Floor 1, 58 Symonds Street, Auckland

Phone: +64 (0)9 3737599 ext 86487

DDI: +64 (0)9 924 6487

Mobile: +64 (0)21 753 189

Email:  <mailto:[email protected]> [email protected]

P Please consider the environment before printing this e-mail 

 

 

From: [email protected]
[mailto:[email protected]] On Behalf Of
Rolf Tschumi
Sent: Tuesday, 6 March 2012 2:59 a.m.
To: [email protected]
Subject: [mrtg] Hilfe

 

Wie kann ich mit mrtg / cfgmaker  einen Cisco 6509 mit CATos  die Interfaces
Monitoren ?

_______________________________________________
mrtg mailing list
[email protected]
https://lists.oetiker.ch/cgi-bin/listinfo/mrtg