Re: MRTG not draw outbound traffic
Steve Shipway <[email protected]>
| Newsgroups | gmane.network.mrtg.user |
|---|---|
| Message-ID | <7294716191A1E142B80615ED2C633BCA5788551A@uxcn10-2.UoA.auckland.ac.nz> |
Check that the ifOutOctets counter is actually increasing - MRTG graphs the rate of increase, so possibly the rate is zero. The number looks rather small. Check that the rate of increase is not greater than AbsMax (100Mbps), since if it is, it will be ignored. If the device supports SNMPv2, use that by having the :::::2 suffix on the target -- Targets[xxxx_8]: 8:public@xxxx:::::2 Some SNMP agents support v1 or v2c correctly but not the other. Steve Steve Shipway University of Auckland ITS UNIX Systems Design Lead [email protected]<mailto:[email protected]> Ph: +64 9 373 7599 ext 86487 ________________________________ _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg