Re: Two devices, one graph?

The PseudoZero solution worked perfectly!


Thank you,
~Christian

-----Original Message-----
From: Tobias Oetiker [mailto:[email protected]] 
Sent: Friday, May 10, 2013 1:47 AM
To: Christian Arnaut
Cc: [email protected]
Subject: Re: [mrtg] Two devices, one graph?

Yesterday Christian Arnaut wrote:

> Have what could be a simple question. When monitoring an SNMP device 
> w/MRTG, is it possible to plot the data from two devices on a single
graph?
>
>
>
> I have two temperature probes. I would like probe #1 (indoor temp) 
> displayed as the I value and probe #2 (outdoor temperature) as the O
value.
>
>
>
> Currently I am monitoring the indoor temp with the noo option enabled.
>
> Target[ncr-temp]:
> 1.3.6.1.4.1.3854.1.2.2.1.16.1.3.0&1.3.6.1.4.1.3854.1.2.2.1.16.1.8.0:pu
> blic@1
> 0.44.1.60
>
>
>
> I also have a second temp probe (also noo option) on a different IP 
> address measuring outdoor temperature.
>
> Target[outdoor-temp]:
> 1.3.6.1.4.1.3854.1.2.2.1.16.1.3.0&1.3.6.1.4.1.3854.1.2.2.1.16.1.8.0:pu
> blic@1
> 0.1.1.60
>
>
>
> Would love to modify the syntax of the Target line in the cfg file to 
> support polling the I & O values from different devices.
>
> Something like below, but this doesn't seem to work.
>
>
>
> 1.3.6.1.4.1.3854.1.2.2.1.16.1.3.0:[email protected]&1.3.6.1.4.1.3854.1
> .2.2.1
> .16.1.3.0:[email protected]
>
>

Target[temp]: PseudoZero&1.3.6.1.4.1.3854.1.2.2.1.16.1.8.0:[email protected]
 + 1.3.6.1.4.1.3854.1.2.2.1.16.1.3.0&PseudoZero:[email protected]

should do the trick

cheers
tobi




>
>
>
> Thank you, in advance, for any assistance. I have search the forums 
> and found that others have asked the same fundamental, however the 
> links to the solutions are dead links.
>
>
>
>
>
> ~Christian
>
>
>
>

--
Tobi Oetiker, OETIKER+PARTNER AG, Aarweg 15 CH-4600 Olten, Switzerland
http://it.oetiker.ch [email protected] ++41 62 775 9902 / sb: -9900