Re: kMG question / problem

This looks like the same problem I mentioned on August 26 and September 12. 
I also used kMG "M,G,T,P". It also worked correctly only for the  daily 
graph, and produced erroneous results for the weekly, monthly and yearly 
graphs. I never received a reaction. So, I am still waiting for a solution.

"Kevin M. Harrington"  wrote in message 
news:[email protected]...
>
>Hello,
>
>I hope I'm not sending a repeat question, but I've searched the archives
>and can't find an answer to my question.
>
>I'm using MRTG to log traffic through my router, and would prefer that
>everything be reported in MB/s. I've used the kMG option to adjust the
>format of the text that is displayed below the graphs and this works.
>However, after doing this, the Week, Month, and Year graphs display in
>base units (bits). The data is correct, however it is hard to read
>because along the left-side of the graph the units are huge. Here's a
>text example of how the left hand side of the weekly, monthly, and
>yearly graphs look:
>
>44000000.0
>33000000.0
>22000000.0
>11000000.0
>0.0
>
>I would prefer that it look like the Daily graph:
>
>44.0 M
>33.0 M
>22.0 M
>11.0 M
>0.0 M
>
>Here is the relevant section of my configuration file:
>
>Target[eth0vlan8]: 6:[email protected]:
>SetEnv[eth0vlan8]: MRTG_INT_IP="x.x.x.x" MRTG_INT_DESCR="eth0.8"
>MaxBytes[eth0vlan8]: 5625000
>kMG[eth0vlan8]: -,-,M,G,T,P
>Title[eth0vlan8]: Traffic Analysis for eth0 / vlan8
>PageTop[eth0vlan8]: <h3>Traffic Analysis for eth0 / vlan8</h3>
>
>Any help / suggestions would be greatly appreciated!