Re: DSCP/COS stats on Cisco router

On 9/23/14, 7:11 AM, "Volk,Gregory B" <[email protected]> wrote:

>Initially I attempt to make this a cfgmaker interface template but I ran
>into problems because I needed to base the indexes off of cbQosIfIndex
>(.1.3.6.1.4.1.9.9.166.1.1.1.1.4) and not the regular mib2 interfaces
>index. However I also had to get the port descriptions from mib2 IfDescr,
>and port speeds from mib2 ifSpeed, and combine those tables with the
>cbQosIfIndex table to make a useful MRTG target.
>Then there were issues with classes that had undefined speeds and
>classnames so those had to be sanity checked and potentially skipped.
>That is what those warnings on lines 247 and 255 are.

Sounds like a better job for a host-template than an interface template.
I recall working with that mib and agree that the data layout is pretty
egregious.

>
>Bottom line is that while I prefer to use something more standardized and
>portable like cfgmaker templates, this cbqos mib just had too many
>oddball exceptions.
>

Configmaker host templates do a lot of the work for you - selecting
ifSpeed or ifHCSpeed depending on what¹s available, for example.  If I had
a few hours I would take a crack at itŠ


>
>
>
>
>
>If you are not the intended recipient of this message (including
>attachments), or if you have received this message in error,  immediately
>notify us and delete it and any attachments.
>
>If you do not wish to receive any email messages from us, excluding
>administrative communications, please email this request to
>[email protected] along with the email address you wish to
>unsubscribe.
>
>For important additional information related to this email, visit
>www.edwardjones.com/US_email_disclosure. Edward
>D. Jones & Co., L.P. d/b/a Edward Jones, 12555 Manchester Road, St.
>Louis, MO 63131 © Edward Jones. All rights reserved.
>
>
>-----Original Message-----
>From: Steve Shipway [mailto:[email protected]]
>Sent: Monday, September 22, 2014 4:30 PM
>To: Volk,Gregory B; [email protected]
>Subject: RE: DSCP/COS stats on Cisco router
>
>This looks useful (even though I'm not 100% certain what these MIB items
>are
>:) ) ; however, it might be a good idea to change it into a cfgmaker host
>template and/or interface template?  That way, one could hook it in on a
>generic cfgmaker run -- and if it can be made to probe for the objects
>existence and have a null operation on an incompatible device it would be
>able
>to be merged with a generic host template...
>
>Steve
>
>Steve Shipway
>[email protected]
>
>
>_______________________________________________
>mrtg mailing list
>[email protected]
>https://lists.oetiker.ch/cgi-bin/listinfo/mrtg