Re: help with configuration for a Cisco SG300-28 switch
Steve Shipway <[email protected]>
| Newsgroups | gmane.network.mrtg.user |
|---|---|
| Message-ID | <5820DC553954E44FA1A36C78323AD14859ED2DC2@uxcn10-tdc06.UoA.auckland.ac.nz> |
You might try just using the standard MRTG cfgmaker to generate a cfg file -- probably use SNMPv2 if you can. You can also find a cisco host template for cfgmaker at www.steveshipway.org/cfgmaker which will give you a few more things (like CPU, memory etc if available). You're not likely to be able to get usage by IP - since the device is very unlikely to collect this - but you'll be able to get the per-port usage statistics, which may amount to the same thing if you have one host per port. Of course first make sure that you have SNMP ACLs configured correctly on the device so that the MRTG host can send SNMP queries... Steve Steve Shipway University of Auckland ITS UNIX Systems Design Lead [email protected] Ph: +64 9 373 7599 ext 86487 ________________________________________ From: mrtg [[email protected]] on behalf of Ben Conner [[email protected]] Sent: Saturday, 31 January 2015 5:35 p.m. To: [email protected] Subject: [mrtg] help with configuration for a Cisco SG300-28 switch Hi, I'm trying to get a clue on how to bring in a SG300 switch into mrtg and so far haven't had much luck. Does anyone have some steps on how to get one of these going? One thing I saw was a multitude of mibs for it. I'm looking for basic bandwidth usage and even better, usage by IP address and/or port #. Much appreciated! --Ben -- Ben Conner [email protected] Web World, Inc. 888-206-6486 or PO Box 1122 480-704-2000 Queen Creek, AZ 85142 _______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg