[Q] latency toggle problem
Moon-Sang Lee <[email protected]>
| Newsgroups | gmane.network.myrinet.general |
|---|---|
| Message-ID | <[email protected]> |
Hello, there
I'm testing my own MCP on myrinet which use Lanai 7.2.
And I found that the latency toggles whenever I reload my MCP and kernel
driver. When I first load my MCP, it seems perform well and shows X latency.
And then if I reload my MCP after I test the correctness of my MCP, it also
seems perform well but shows Y latency.(where X > Y)
And if I reload my MCP again, it shows Z latency.(where {X,Z} > Y)
Ok. reload again. then it shows it shows A latency.(where {X,Z} > {Y,A})
And this toggle of latency continues whenever I load my MCP.
Is there anybody who experienced similar situations?
Thanks for reading and any comment will be welcome.
--
-------
Moonsang Lee [email protected]
homepage URL http://camars.kaist.ac.kr/~mslee