Re: board not found error

[email protected] Sat, 4 Dec 2004 23:42:40 +0900
Newsgroups gmane.network.myrinet.general
Message-ID <[email protected]>
problem solved, my fault. ;)
I have run self-made device driver for myrinet NIC before running gm.
It might distort the kernel. I can run gm after rebooting the server.
Anyway thanks a lot.


On Sat, Dec 04, 2004 at 10:16:25PM +0900, mslee wrote:
> 
> Hello. I am trying to use four myrinet NICs (M2L-PCI64B) on P4 Xeon
> server
> which runs SuSe Linux 8.2. I've adopted NIC into 66MHz 64bit PCI slot.
> As shown below, NIC seems to be detected on the slot.
> 
> ####### result of 'cat /proc/pci'
> Bus  2, device   2, function  0:
> Class ffff: PCI device 14c1:8043 (MYRICOM Inc.) (rev 255).
> IRQ 55.
> Master Capable.  Latency=255.  Min Gnt=255.Max Lat=255.
> Prefetchable 32 bit memory at 0xe8000000 [0xe8ffffff].
> #######
> 
> I've installed GM-1.6.5. But I've found "No boards found" error message
> when I try to run gm with "gm start" command as described in GM
> installation
> guide. The full message in /tmp/gm_log.root is as below.
> What's wrong with me? Any comments will be welcome.
> Thanks..
> 
> P.S. One more question.. Does PCI-64B NIC operate on PCIX slot? 
> 
> 
> #######
> myserver:~ # more /tmp/gm_log.root
> Sun Dec  5 04:36:37 KST 2004
> /etc/init.d/gm start
>         root@myserver> test xgm != x
> 		Starting gm...
>         root@myserver> /home/gmuser/MYRICOM/gm_1.6.5/bin/gm_board_info
> 		GM build ID is "1.6.5_Linux
> gmuser@myserver:/home/gmuser/temp/gm-1.6.5_Linux Sun Dec  5 04:24:35 KST 2004."
>         No boards found
>         root@myserver> rmmod gm
>         rmmod: module gm is not loaded
>         root@myserver> insmod gm
>         Using /lib/modules/2.4.20-64GB-SMP/gm/gm.o
>         Warning: loading /lib/modules/2.4.20-64GB-SMP/gm/gm.o will taint the kernel: non-GPL license - Myricom
>           See http://www.tux.org/lkml/#export-tainted for information about tainted modules
>           /lib/modules/2.4.20-64GB-SMP/gm/gm.o: init_module: No such device
>           Hint: insmod errors can be caused by incorrect module parameters, includ ing invalid IO or IRQ parameters.
>                You may find more information in syslog or the output from dmesg
> ############################
> Could not install GM module.
> ############################
> 
> 
> -------------Korea Advanced Institute of Science and Technology--------------
> Moonsang Lee	    [email protected]
> CS dept. KAIST      +82-42-869-5585@calab  
> Sarang Kwan. 524    +82-42-879-4145@dormitory
> homepage URL        http://camars.kaist.ac.kr/~mslee
> ----------------------Computer Architecture Laboratory-----------------------


-------------Korea Advanced Institute of Science and Technology--------------
Moonsang Lee	    [email protected]
CS dept. KAIST      +82-42-869-5585@calab  
Sarang Kwan. 524    +82-42-879-4145@dormitory
homepage URL        http://camars.kaist.ac.kr/~mslee
----------------------Computer Architecture Laboratory-----------------------