RE: GM-2.0.24_Linux mapper not showing all hosts

You bet. I have a cable problem. If fully seated will not turn the LED
on but if half seated will.

Should the green LED's be blicking about 6 times a second on both switch
and NIC?

Thanks,

--
Valmor

x1 ~ # /opt/gm/bin/gm_board_info
GM build ID is "2.0.24_Linux_rc20051223164441PST
root@x1:/root/third-party/gm-2.0.24_Linux Thu May 11 02:59:38 EDT 2006."


Board number 0:
  lanai_clockval    =3D 0x082082a0
  lanai_cpu_version =3D 0x0900 (LANai9.0)
  lanai_board_id    =3D 00:60:dd:7f:63:2a
  lanai_sram_size   =3D 0x00200000 (2048K bytes)
  max_lanai_speed   =3D 134 MHz
  product_code      =3D 109
  serial_number     =3D 89070
    (should be labeled: "M3S-PCI64B-2-89070")
LANai time is 0x10c09fcee ticks, or about 33 minutes since reset.
Mapper is 00:60:dd:7f:63:36.
Map version is 617017.
2 hosts.
Network is fully configured.
This node is "x1"
Board has room for 16 ports,  2165 nodes/routes,  32768 cache entries
          Port token cnt: send=3D61, recv=3D253
Port: Status  PID
   0:   BUSY  7571  (this process [gm_board_info])
   1:   BUSY  7500 =20
Route table for this node follows:
gmID MAC Address                                 gmName Route
---- ----------------- --------------------------------
---------------------
   1 00:60:dd:7f:63:2a                               x1 (this node)
   2 00:60:dd:7f:63:36                               x2 81 (mapper)


> -----Original Message-----
> From: Reese Faucette [mailto:[email protected]]
> Sent: Thursday, May 11, 2006 1:24 PM
> To: de Almeida, Valmor F.; [email protected]
> Cc: [email protected]
> Subject: Re: [Myrinet] GM-2.0.24_Linux mapper not showing all hosts
>=20
> > The LED light for the master node (x1) on the switch is off,
> > and the corresponding yellow LED on the NIC card is blinking but the
> > green LED is off. On the slave node the LED on the switch is
blinking,
> > so is the green and yellow LEDs on the corresponding NIC. The
> > gm_board_info does not show both nodes.
>=20
> there's your problem.  the master node is not acutally connected to
the
> switch.  either your fiber needs to be reseated or replaced.  given
that,
> the mapper is behaving as expected, since you have two independent
1-node
> fabrics ;-)
>=20
> regards,
> -reese
>=20