Re: Patch for build instructions
Bill Fenner <[email protected]>
| Newsgroups | gmane.network.net-snmp.devel |
|---|---|
| Message-ID | <CAF4SogYvT7tv=aHY=bhCUKY5vbnDjAOGcF+P7c0u1ht=FKsDtQ@mail.gmail.com> |
On Thu, Mar 22, 2018 at 9:37 AM, Bart Van Assche <[email protected]> wrote: > On 03/21/18 19:47, Eric S. Raymond wrote: > >> - 3) make >>> >> + 3) Run make. If the build fails with a complaint that it can't resolve >> + -lperl, install libperl-dev and try again. >> > This should be elaborated further: another alternative is to pass > --disable-embedded-perl to the configure script. Not to mention that "install libperl-dev" means nothing on Solaris, or FreeBSD, or MacOS, or other supported systems. The best solution here would be to make configure recognize that it doesn't have the prerequisites available. Bill ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Net-snmp-coders mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/net-snmp-coders