Re: RFC: "-@" command line argument to set clientaddr per request/session
Robert Story <[email protected]>
| Newsgroups | gmane.network.net-snmp.devel |
|---|---|
| Message-ID | <[email protected]> |
On Wed, 2 May 2018 11:49:46 -0400 Bill wrote: BF> Is it too late to add this? This occurs to me just because it’s BF> an easier way to test the transports’ support of clientaddr, by BF> being able to set clientaddr dynamically via the command line, BF> and I just noticed that this is broken in 5.8. This would duplicate functionality.. Pretty much any config option can be set on the command line using '--TOKEN-VALUE'. e.g. snmpget [...] --clientaddr=192.168.1.111 [...] Robert ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Net-snmp-coders mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/net-snmp-coders