Re: considerations for porting net-snmp to uClinux

I am building under ubuntu linux using toolchain for the target embedded
system, uClinux.
The target is put into flash mode, where the built image is downloaded and
then flashed on target embedded system.
Then target is rebooted.

On Fri, Jun 22, 2018 at 11:21 PM, Magnus Fromreide <[email protected]>
wrote:

> How did you install it on the target system?
>
> /MF
>
> On Tue, Jun 19, 2018 at 02:56:17PM -0500, John Emrich wrote:
> > I should also I am trying to build net-snmp using shared libraries.
> >
> > On Tue, Jun 19, 2018 at 2:54 PM, John Emrich <[email protected]>
> > wrote:
> >
> > > Hello,
> > >
> > > When building net-snmp for uClinux, are there any special
> considerations?
> > >
> > > I have already addressed mmu-less considerations by using the
> appropriate
> > > toolchain. The problem appears when I start snmpd, it crashes. In fact
> it
> > > appears to crash prior to executing 1st statement, as if it was in the
> > > dynamic linker.
> > >
> > > --
> > > Thank you
> > > John Emrich
> > >
> > >
> >
> >
> > --
> > Thank you
> > John Emrich
> > Optimal Design
> > 847-818-1000 x39
>
> > ------------------------------------------------------------
> ------------------
> > Check out the vibrant tech community on one of the world's most
> > engaging tech sites, Slashdot.org! http://sdm.link/slashdot
>
> > _______________________________________________
> > Net-snmp-coders mailing list
> > [email protected]
> > https://lists.sourceforge.net/lists/listinfo/net-snmp-coders
>
>


-- 
Thank you
John Emrich
Optimal Design
847-818-1000 x39

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot

_______________________________________________
Net-snmp-coders mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/net-snmp-coders