Confirmation Regarding Special Characters in SNMP Configuration

Dear All,

As part of my Agent Configuration, I'm planning to provide an User
Interface to configure the SNMP Configuration like Read-Only Community,
Read-Write Community and all including SNMPv3.

Now the issue is whether the SNMP Agent and SNMP Utilities will be able to
process all special characters or not. Because when I configure with the
special characters `~!@#$%^&*()_+-=:;"[]{}|,.<>/? it works like a charm.

But when I configure with '(single quote) or \(back slash) then the issue
arises like no response with an Authentication Failure Trap.

So based on this observation, can I block only these *two characters* only
in the validation along with following validation?

- No space allowed
- No special characters in the beginning and end
- Min Length should be 6 and max length should be 32

Please correct me if I'm doing wrong!

*Note: *This validation is applicable for Read-Only Community, Read-Write
Community, SNMPv3 User Name, Privacy Key and Authentication Password.

-- 
With Best Regards,
Anandaprabu V <https://www.linkedin.com/in/anandaprabu-v-10867671/>
VVDN Technologies Pvt. Ltd <http://www.vvdntech.com/>, Chennai
Cell : +91 9500650885 | Skype : prabuvaradharajan

_______________________________________________
Net-snmp-coders mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/net-snmp-coders