Re: Interface down - Solaris 8

On Wed, 10 Aug 2005 15:14:47 -0400 P.Taylor wrote:
PT> interfaces.c from 5.1.3/5.1.3.1 
PT> (2 seperate installs) did not work.

So they work ok in a 5.1.3 install, but not when copied over to 5.2.1, right?
That's odd.

PT> I have installed the binary 5.0.9.
PT> It sees the interface as up both ifOperStatus and 
PT> ifAdminStatus. Now a new problem.....:(
PT> 
PT> snmpget -v 2c -c xxxxx localhost IF-MIB::ifSpeed.2 = Gauge32: 100
PT> 
PT> How do I augment this value to be the correct 100Mbit interface
PT> (how do I add 6 more zeros to this)
PT> value or do I have to get source and recompile?

You can try the interface directive in snmpd.conf, but I seem to recall that
it doesn't work for solaris..

-- 
NOTE: messages sent directly to me, instead of the lists, will be deleted
      unless they are requests for paid consulting services.

Robert Story; NET-SNMP Junkie
Support: <http://www.net-snmp.org/> <irc://irc.freenode.net/#net-snmp>  
Archive: <http://sourceforge.net/mailarchive/forum.php?forum=net-snmp-users>

You are lost in a twisty maze of little standards, all different. 


-------------------------------------------------------
SF.Net email is Sponsored by the Better Software Conference & EXPO
September 19-22, 2005 * San Francisco, CA * Development Lifecycle Practices
Agile & Plan-Driven Development * Managing Projects & Teams * Testing & QA
Security * Process Improvement & Measurement * http://www.sqe.com/bsce5sf
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users