Re: NET-SNMP can not translate multi-index!

On Tue, 30 Aug 2005 09:51:21 +0800 Ying wrote:
YW> 2. After recompile and reinstall net-snmp, I can use name to access
YW> uni-index table and scalar data.
YW> 
YW>    But, access to multi-index table fails!
YW> 
YW>    2.1 Run net-snmp with debug "snmpd -D", the debug information stops
YW> in:
YW> 
YW>        ......
YW> 
YW>        trace: netsnmp_handle_request(): snmp_agent.c, 2975:
YW> 
YW> results: request results (status = 0):
YW> 
YW> trace: netsnmp_handle_request(): snmp_agent.c, 2978:
YW> 
YW> results: (stop here!)
YW> 
YW>    2.2 Run net-snmp without debug "snmpd", "segment fault" appears!

This would indicate a problem with your module code. If you are having
problems with an application crashing, it is very helpful to have a backtrace
(aka stack trace) at the point of the crash. If you can run the application
with GDB and reproduce the problem, the 'backtrace' command should print this
information for you.

-- 
NOTE: messages sent directly to me, instead of the lists, will be deleted
      unless they are requests for paid consulting services.

Robert Story; NET-SNMP Junkie
Support: <http://www.net-snmp.org/> <irc://irc.freenode.net/#net-snmp>  
Archive: <http://sourceforge.net/mailarchive/forum.php?forum=net-snmp-users>

You are lost in a twisty maze of little standards, all different. 


-------------------------------------------------------
SF.Net email is Sponsored by the Better Software Conference & EXPO
September 19-22, 2005 * San Francisco, CA * Development Lifecycle Practices
Agile & Plan-Driven Development * Managing Projects & Teams * Testing & QA
Security * Process Improvement & Measurement * http://www.sqe.com/bsce5sf
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users