Re: Can mib2c support more than one table in a MIB?

On Wed, 31 Aug 2005 06:23:52 -0500 Paul wrote:
HP> My experience with Mib2c is that you can use it one more then one table,
HP> but you'll end up with several very similar c files.  The "secret" is to
HP> run mib2c multiple times.  For instance, if your mib defines 3 tables
HP> (MyTable1, MyTable2, and MyTable3) then you can do
HP> env MIBS="+MY_MIB" mib2c -c mib2c.mfd.conf MyTable1
HP> env MIBS="+MY_MIB" mib2c -c mib2c.mfd.conf MyTable2
HP> env MIBS="+MY_MIB" mib2c -c mib2c.mfd.conf MyTable3

Most conf files will deal with multiple tables in a MIB, but mib2c.mfd.conf is
an exception. The suggested solution, running it once for each table, is the
temporary workaround solution.

-- 
NOTE: messages sent directly to me, instead of the lists, will be deleted
      unless they are requests for paid consulting services.

Robert Story; NET-SNMP Junkie
Support: <http://www.net-snmp.org/> <irc://irc.freenode.net/#net-snmp>  
Archive: <http://sourceforge.net/mailarchive/forum.php?forum=net-snmp-users>

You are lost in a twisty maze of little standards, all different. 


-------------------------------------------------------
SF.Net email is Sponsored by the Better Software Conference & EXPO
September 19-22, 2005 * San Francisco, CA * Development Lifecycle Practices
Agile & Plan-Driven Development * Managing Projects & Teams * Testing & QA
Security * Process Improvement & Measurement * http://www.sqe.com/bsce5sf
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users