Re: clarrification on "agentaddress" in snmpd.conf
Dave Shield <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On Wed, 2005-10-12 at 16:48 +0800, Ronnel P. Maglasang wrote: > Is this directive the same as specifying the listening address(es) > in the command line? Yes. > But I got the following error: > > Error opening specified endpoint "udp:161" > Server Exiting with code 1 My test system doesn't have IPv6 support, but I've tried an equivalent setup with two different UDP ports, and it works as expected. snmpd udp:161,udp:1616 and agentAddress udp:161,udp:1616 give exactly the same effect - listening on both ports. > I'd like snmpd to run > on udp6:161 and udp:161 and specify them from the config file > (snmpd.conf?) and not from the command line. Is this possible? Yes - agentAddress will do exactly that. Which version of the agent are you using? Dave ------------------------------------------------------- This SF.Net email is sponsored by: Power Architecture Resource Center: Free content, downloads, discussions, and more. http://solutions.newsforge.com/ibmarch.tmpl _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users