RE: accessing udpInDatagrams need some information
"rajeshreddy" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
hi, problem was solved .. there was a mistake in context access.. Iam using 5.0.6 version on linux.. if any thing you want to suggest regarding this ,please mail me Thanks ... Regards, Rajesh. -----Original Message----- From: [email protected] [mailto:[email protected]]On Behalf Of rajeshreddy Sent: Thursday, December 01, 2005 12:23 PM To: [email protected] Subject: accessing udpInDatagrams need some information hi, I want to access udpInDatagrams (.iso.org.dod.internet.mgmt.mib2.udp. .1.3.6.1.2.1.7.1.0) from a manager application. I tried to verify whether udp is initialized or not by the command ./snmpd -Dmib_init -H mib_init: initializing: ipv6 mib_init: initializing: system_mib mib_init: initializing: sysORTable mib_init: initializing: at mib_init: initializing: interfaces mib_init: initializing: snmp_mib mib_init: initializing: tcp mib_init: initializing: icmp mib_init: initializing: ip mib_init: initializing: udp mib_init: initializing: vacm_vars mib_init: initializing: setSerialNo mib_init: initializing: memory mib_init: initializing: vmstat mib_init: initializing: proc mib_init: initializing: versioninfo mib_init: initializing: pass mib_init: initializing: pass_persist mib_init: initializing: disk mib_init: initializing: loadave mib_init: initializing: extensible mib_init: initializing: errormib mib_init: initializing: file mib_init: initializing: dlmod mib_init: initializing: proxy mib_init: initializing: snmpEngine mib_init: initializing: snmpMPDStats mib_init: initializing: usmStats mib_init: initializing: usmUser mib_init: initializing: snmpNotifyTable mib_init: initializing: snmpNotifyFilterTable mib_init: initializing: snmpNotifyFilterProfileTable mib_init: initializing: snmpTargetAddrEntry mib_init: initializing: snmpTargetParamsEntry mib_init: initializing: target_counters mib_init: initializing: nsTransactionTable mib_init: initializing: nsModuleTable mib_init: initializing: subagent mib_init: initializing: override mib_init: initializing: hr_system mib_init: initializing: hr_storage mib_init: initializing: hr_device mib_init: initializing: hr_other mib_init: initializing: hr_proc mib_init: initializing: hr_network and some more..................... i added these lines in snmpd.conf file com2sec me default public group RWGroup v1 me group RWGroup v2c me view udpview included .1.3.6.1.2.1.7 access RWGroup "" any noauth exact udpview none none stopped snmpd and then started it..other changes are reflecting but it is not able to access udp subtree Will this be ok to access .1.3.6.1.2.1.7.1.0 or anything else to be done manager gives errorstatus 2 (no such OID) at this oid index. helpme in solving this. thanks in advance. Regards, Rajesh. The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s)and may contain confidential or privileged information. If you are not the intended recipient, please notify the sender or [email protected]