RE: mib2c not working, perl module perl/SNMP not installed correc tly

Hi Erez, I had the same problem. The solution is to install the Net-SNMP
package (the rpm file). Once you install the package the adequate Perl
module installs and mib2c start working. You may have to use the -force
directive to install this rpm...

 

Hope this helps.

Shuki

 

  _____  

From: [email protected]
[mailto:[email protected]] On Behalf Of Makavy,
Erez (Erez)
Sent: Sunday, December 11, 2005 11:17 AM
To: [email protected]
Subject: mib2c not working, perl module perl/SNMP not installed correctly

 

Hi,

 

Please help with this installation problem, I'm stuck !

 

The problem summery :

--------------------------------

*	 mib2c does not work !

 

Problem characteristics:

----------------------------------

*	running mib2c complains that the SNMP perl module is not installed,
showing this message:

ERROR: You don't have the SNMP perl module installed.  Please obtain
this by getting the latest source release of the net-snmp toolkit from
http://www.net-snmp.org/download/ <http://www.net-snmp.org/download/>  .
Once you download the source and
unpack it, the perl module is contained in the perl/SNMP directory.
See the README file there for instructions.

 

*	make test in the perl directory fails with message:

make[1]: Entering directory
`/root/download/net-snmp-5.2.2/perl/default_store'
PERL_DL_NONLAZY=1 /usr/bin/perl "-I../blib/lib" "-I../blib/arch" test.pl
1..64
Can't load '../blib/arch/auto/NetSNMP/default_store/default_store.so' for
module NetSNMP::default_store: libnetsnmp.so.9: cannot open shared object
file: No such file or directory at
/usr/lib/perl5/5.8.6/i386-linux-thread-multi/DynaLoader.pm line 230.
 at test.pl line 71
Compilation failed in require at test.pl line 71.
BEGIN failed--compilation aborted at test.pl line 71.

Installation notes:

-------------------------

*	I'm downloaded and unpacked net-snmp-5.2.2 tar file, onto a Linux
2.6.11 system (Fedora distribution), on a PC.
*	As root user, in the decompressed directory, I ran:

*	./configure --with-perl-modules
*	make
*	make install

*	No errors occured in either stage.

Solutions attempted:

-----------------------------

*	make uninstall, make clean, and try the whole thing again.
*	check that the file
perl/blib/arch/auto/NetSNMP/default_store/default_store.so' exists. --> it
does
*	verify that the SNMP module was installed by commiting : perldoc
perllocal --> module Bundle::NetSNMP is installed at
/usr/lib/perl5/site_perl/5.8.6, LINKTYPE : Dynamic
*	Try installing on a different PC (running also Linux) --> it works
just fine, but I want to fix this one.

 

----------------

Any ideas?

----------------

 

Thanks in advance,

Erez Makavy.