RE: Unable to Generate Traps on Processes, etc...

Thanks. Any comments on the rest?
 
Also, I've tried starting the snmpd process with the "-Dmte" and "-D" options, but there is no output. The process simply starts.
 
Thanks again,
David

________________________________

From: Dave Shield [mailto:[email protected]]
Sent: Mon 3/20/2006 10:12 AM
To: Billington, David
Cc: [email protected]
Subject: RE: Unable to Generate Traps on Processes, etc...



On Mon, 2006-03-20 at 10:09 -0600, Billington, David wrote:

> > trapsink        <ip_addr1>
> > trapsink        <ip_addr2>
> > trapsink        <ip_addr3>
> > informsink      <ip_addr1>
> > informsink      <ip_addr2>
> > informsink      <ip_addr3>
>
> Why do you want to send *two* copies of each trap to each
> of these destinations?  Please use *EITHER* "trapsink" *OR*
> "informsink" for any given host receiver.  Not both.
>
> --Thanks, I've removed the 'trapsink' lines. Just to confirm, the
> remaining 'informsink' lines will send all generated traps to the
> specified destinations?--

Yes.
You should see three copies of each notification (as an SNMPv2c
INFORM request), being sent every time.


Dave


============================================================
The information contained in this message may be privileged
and confidential and protected from disclosure. If the reader
of this message is not the intended recipient, or an employee
or agent responsible for delivering this message to the
intended recipient, you are hereby notified that any reproduction,
dissemination or distribution of this communication is strictly
prohibited. If you have received this communication in error,
please notify us immediately by replying to the message and
deleting it from your computer. Thank you. Tellabs
============================================================