Re: Inform Destination

Hello,

Wes, thank you very much for your answer !

I've got 2 types of questions about the use of these 2 MIBs (I've looked 
at all the net-snmp documentation but couldn't find an answer)

1. I've defined my own traps in one private MIB but I don't understand how 
to use the SNMP-NOTIFICATION-MIB.
Should I register my traps in this MIB ?

2. In my snmpd.conf, I use the option 'informsink' to specify to the agent 
where to send the informs. Should I see this target address in the 
SNMP-TARGET-MIB ?
if not, if I add (via snmpset) the same address in this MIB, does the 
inform sent twice ?
If I add a target in the SNMP-TARGET-MIB, is it persistent ? ie is this 
information will be still there after an agent reset ?

thanks for any information
best regards
Celine

Wes Hardaker <[email protected]> wrote on 04/03/2006 11:14:46 
AM:

> >>>>> On Fri, 31 Mar 2006 17:20:02 -0600, <[email protected]> 
said:

> cherrero> Does a MIB exist, including parameters to set addresses
> cherrero> where to send informs ?  Actually, I'm looking for a way to
> cherrero> configure inform destination address remotly.

> Yes, the combination of the NOTIFICATION-MIB and the TARGET-MIB (both
> of which are IETF standard MIBs) can be used to configure trap 
destinations.
> --
> Wes Hardaker
> Sparta, Inc.