informs and traps....

Hi,
 
My setup  for snmp traps/informs goes as below.
 
snmp agent setup(snmpd running on 192.168.31.114)
------------------------------------------------------------------------
-------
 
my /usr/local/share/snmp/snmpd.conf file contains following
configuration.
#----------------------------------snmpd.conf
begins----------------------------------------------
 
agentSecName                    raghu
defaultMonitors                    yes
linkUpDownNotifications       yes
authtrapenable                    1
authcommunity read brcm default
trapsess -v 2c -c brcm 192.168.31.199:162
trapsess -v 3 -Ci -u raghu -l authNopriv -a MD5 -A testraghu -t 10 -r 3
192.168.31.199:162
 
#----------------------------------snmpd.conf
ends----------------------------------------------
 
with this configuration I am enabling snmpd on 192.168.31.114.
 
snmptrapd has following setup (snmptrapd on 192.168.31.199)
------------------------------------------------------------------------
-------------------------
My /var/net-snmp/snmptrapd.conf file has following configuration.
#----------------------------------snmptrapd.conf
begins----------------------------------------------
 
createUser raghu MD5 testraghu DES testraghu
#which gets encrypted once I enable snmptrapd
#----------------------------------snmptrapd.conf
ends----------------------------------------------
 
My /usr/local/share/snmp/snmptrapd.conf file has following
configuration.

#----------------------------------snmptrapd.conf
begins----------------------------------------------
 
authcommunity read,write brcm default
 
#    if  I dont use authcommunity I will get following error
#    [root@localhost raghu]# /usr/local/sbin/snmptrapd
#    No log handling enabled - turning on stderr logging
#    Warning: no access control information configured.
#    This receiver will *NOT* accept any incoming notifications.

traphandle default 192.168.31.114

#----------------------------------snmptrapd.conf
ends----------------------------------------------
 
Once I enable snmptrapd on 192.168.31.199 as given below
 
/usr/local/sbin/snmptrapd -f -Le -c /usr/local/share/snmp/snmptrapd.conf
 
snmptrapd runs in  fore ground. At the other side I tried killing and
restarting snmpd since it is coldStrat I should get traps/informs saying
its cold start. Which I unable to get.
 
Actually I am able to get traps/informs for v2 when I test with MG-SOFT
Mib Browser or AdventNet SNMP Utilities. But I am not getting it with
snmptrapd.
 
Can  anyone  just tell me whats wrong with my configuration or testing
of the feature. Any thing  less or extra I need to do?
 
Thanx & Regards,
Raghavendra. S