Can't get SDISK nor THOLD snmp traps from Filer

Hello,

I'm using Data ONTAP 7.0.3 P4 and Net-SNMP 5.0.3.1

I want to receive SNMP traps when DISK and THOLD/SDISK quotas are exceeded.

I can get DISK exceeded SNMP traps, but I never receive THOLD/SDISK exceeded SNMP traps, nor Syslog messages.

------------------------------------------------------------------------------------------------------------------------------------------------
Here's my snmptrapd.conf file:

		# Access control disabled
		disableAuthorization yes


		# Enterprise specific trap
		traphandle default c:/usr/bin/trapProcessor.bat
------------------------------------------------------------------------------------------------------------------------------------------------

Is there any file to be configured on the host filer, in order to set that all snmp traps should be sent ?

Thanks in advance

Regards,
Fabrice




This e-mail is intended only for the above addressee. It may contain
privileged information. If you are not the addressee you must not copy,
distribute, disclose or use any of the information in it. If you have
received it in error please delete it and immediately notify the sender.
Security Notice: all e-mail, sent to or from this address, may be
accessed by someone other than the recipient, for system management and
security reasons. This access is controlled under Regulation of
Investigatory Powers Act 2000, Lawful Business Practises.


_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users