Re: Host info not shown

On 01/08/06, Ing. Andrés E. Gallo <[email protected]> wrote:
> I am using net-snmp 5.2.2 over FreeBSD 6.0

Compiled from source, or a binary installation?

> After installing, runing  with the suggested command ( snmpd -f -Le -d -c
> /usr/local/etc/snmpd.conf ), i saw that some queries are ok, with replies,
> but host is empty.

Was the agent configured to include the Host Resources module?
It wasn't part of the default configuration until fairly recently.  I
can't remember whether 5.2.x includes this by default or not - I
suspect not.

net-snmp-config --configure-options

should report what configuration was used.
(That may not be quite the right incantation - see the error message
for the exact parameter to use).

Dave

-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys -- and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users