problem about config snmptrapd,thank you
wenting wang <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
Dear,
I met a problem in using snmptrapd. My OS is Windows NT, the net-snmp binary installed is 5.3.1.
After installation, there are snmpd.conf and snmp.conf in the C:\usr\etc\snmp. I run "snmpd" in the command line ,it works well, "snmpget" can get value from agent, but I run "snmptrapd" in command line, it shows :
Warning: no access control information configured.
This receiver will NOT accept any incoming notifications.
How should I configure to make it work!
Looking forward to your answer! Thank you very much！
---------------------------------
抢注雅虎免费邮箱3.5G容量，20M附件！
-------------------------------------------------------------------------
This SF.net email is sponsored by DB2 Express
Download DB2 Express C - the FREE version of DB2 express and take
control of your XML. No limits. Just data. Click to get it now.
http://sourceforge.net/powerbar/db2/
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users