Re: Facing a problem with Dynamic MIB Module load
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On 09/06/07, mushtaq khan <[email protected]> wrote: > I went through the SNMP tutorial for loading dynamically created MIB > module. But when run the command "snmpset localhost > UCD-DLMOD-MIB::dlmodStatus.1 i load" > > The result i got is : > dlmodStatus.1 = load(4) That is correct. The response to a SET request will always contain the same assignments as the original request. > But the expected result was > dlmodStatus.1 = loaded(1) If you now try a GET request, then that's what you should see. But not following the SET request. Dave ------------------------------------------------------------------------- This SF.net email is sponsored by DB2 Express Download DB2 Express C - the FREE version of DB2 express and take control of your XML. No limits. Just data. Click to get it now. http://sourceforge.net/powerbar/db2/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users