Re: Transmission(10) is not giving any values
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On 12/09/2007, Chiranjib Pal <[email protected]> wrote: > Is there any possibility that transmission values are available in > ucd-snmp?? No. > And if I add dot3.c and dot3.h (7th child of transmission) and then Make the > whole snmp, will net-snmp then support the new configuration?? If you'vecoded the MIB module correctly, then sure. Dave ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users