To self start snmpd when it is killed.

Hi EveryBody,
Actually in my project, the snmpd process will be running. 
Due to some reason if it gets killed, then can be it be self-started 
again.
I know that if the workstation reboots, snmpd will self-start.
But for my requirement, it has to self-start when the workstation is 
running.
Please help me in this regard.

Regards,
Jayanthi P

***********************  Aricent-Private   ***********************
"DISCLAIMER: This message is proprietary to Aricent and is intended solely for the use of 
the individual to whom it is addressed. It may contain privileged or confidential information and should not be 
circulated or used for any purpose other than for what it is intended. If you have received this message in error, 
please notify the originator immediately. If you are not the intended recipient, you are notified that you are strictly
prohibited from using, copying, altering, or disclosing the contents of this message. Aricent accepts no responsibility for 
loss or damage arising from the use of the information transmitted by this email including damage from virus."

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users