RE: Can't set entry in Notification-MIB

> From: [email protected] 
> [mailto:[email protected]] On 
> Behalf Of Steve Kittleson
> Sent: Wednesday, September 19, 2007 9:12 AM

> Am I correct in assuming that setting " rwcommunity private" 
> and "rocommunity public" will allow read/write access to the 
> complete mib tree on the agent?

	You only need the first one for that, but yes.  The view can be restriced, though.

> Has anyone been successful using the standard mibs: 
> Notification-MIB, Target-MIB, and Community-MIB? If so, is 
> anything special required? What is your snmpd.conf setup?

	Nothing special should be required, except the mental gymnastics necessary to beat these MIBs into submission.

> 	2)
> 	[skittleson@stubby bin]$ snmpset -v 2c -t 5 -c private 
> localhost snmpNotifyRowStatus.'steve' i createAndWait
> 	snmpNotifyRowStatus.steve: Unknown Object Identifier 
> (Index out of range: steve (snmpNotifyName))

	I ran the same command, and it created a row.  My config is the output of `snmpconf -g basic_setup`, so no trickery is involved.

	Have you walked snmpNotifyTable to ensure that it was compiled in and you can see it?


	HTH,

Mike

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users