Re: Warning: no access control information configured
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On 17/11/2007, PoWah Wong <[email protected]> wrote: > I had done: > snmpconf -g basic_setup > mv snmpd.conf /usr/local/share/snmp/snmpd.conf That sets up the access configuration for the SNMP agent (snmpd). > # snmptrapd > # tail -f /var/log/messages > Nov 17 16:36:39 tulip snmptrapd[3921]: > Warning: no access control information configured. > This receiver will *NOT* accept any incoming notifications. This message comes from the trap receiver (snmptrapd). That is a different application to snmpd, so uses a different config file (snmptrapd.conf) and different access control directives. Please see the man page for snmptrapd.conf. Dave ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users