Re: --with-mib-modules="ucd-snmp/lmSensors" not working
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On 23/11/2007, PoWah Wong <[email protected]> wrote: > > Things to check: > > - access control: > > - active agent modules: > > # snmpd -f -Le -Ducd-snmp/lmSensors > registered debug token ucd-snmp/lmSensors, 1 > => sensor_init > <= sensor_init OK - so the agent *is* picking up the sensors module. > Warning: no access control information configured. > It's unlikely this agent can serve any useful > purpose in this state. Hmmm.... could that message possibly be relevant? he asked rhetorically..... Dave ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users