Re: problems with rpm installation
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On 21/11/2007, Angela Palladino <[email protected]> wrote: > I'm using net-snmp 5.4.1. I have successfully installed and tested it > using manual commands (configure, make, make install). > I created a rpm package using the spec file, but when I install it > I'have noticed two strange behaviours: > - when agent is launched it takes a while before it starts to work > (approximately 30 secs) Try starting the agent using "snmpd -f -Le ...." Does it report anything interesting while it's starting up? (Particularly in the first 30s, and when things finally start working). > - get of some variables returns unexpected values Like what? > The only difference between the two installations seems to be files > location (i.e. /usr/sbin instead of /usr/local/sbin). That feels like a difference in the way "configure" was run. The default configuration builds everything under /usr/local /usr/sbin would normally be used by a vendor-supplied agent, rather than one you compiled yourself. Dave ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users