Re: problems with rpm installation (solved)

Hi Dave,

thanks for your help; using your command I found out that there was 
an error on the "snmpd.conf" file, that made the snmpd process to hang.

Regarding the other problem (I had a failure on a hard disk test I 
implemented), I solved it disabling SeLinux on my machine.

Angela

At 20.43 25/11/2007, Dave Shield wrote:
>On 21/11/2007, Angela Palladino <[email protected]> wrote:
> > I'm using net-snmp 5.4.1. I have successfully installed and tested it
> > using manual commands (configure, make, make install).
> > I created a rpm package using the spec file, but when I install it
> > I'have noticed two strange behaviours:
> > - when agent is launched it takes a while before it starts to work
> >     (approximately 30 secs)
>
>Try starting the agent using
>     "snmpd -f -Le ...."
>
>Does it report anything interesting while it's starting up?
>(Particularly in the first 30s, and when things finally start working).
>
> > - get of some variables returns unexpected values
>
>Like what?
>
>
> > The only difference between the two installations seems to be files
> > location (i.e. /usr/sbin instead of /usr/local/sbin).
>
>That feels like a difference in the way "configure" was run.
>The default configuration builds everything under /usr/local
>/usr/sbin would normally be used by a vendor-supplied agent,
>rather than one you compiled yourself.
>
>Dave


-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users