Re: Solaris 10 - Counter64 values are not shown
Frank Munsche <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
Hello Thomas, I've built it from scratch again, included the config of section 10. Unfortunately, snmpd doesn' t start cleanly anymore: error on subcontainer 'interface container' insert (-1) error on subcontainer 'interface container' insert (-1) error on subcontainer 'interface container' insert (-1) error on subcontainer 'interface container' insert (-1) error on subcontainer 'interface container' insert (-1) error on subcontainer 'interface container' insert (-1) error on subcontainer 'interface container' insert (-1) error on subcontainer 'interface container' insert (-1) error on subcontainer 'interface container' insert (-1) error on subcontainer 'interface container' insert (-1) On Tuesday 11 December 2007, Thomas Anders wrote: > Frank Munsche wrote: > > So finally, I've built the 5.4.1 from source (32 bit), but the result > > remains the same. No counter64. > > You need to change your compile-time configuration. See the section "10. > MIB rewrites for IF-MIB, TCP-MIB and UDP-MIB" in README.solaris (as shipped > with 5.4.1). > > > +Thomas ------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users