disable initial traps

Meilán García Antonio <[email protected]> Wed, 12 Dec 2007 15:21:16 +0100

Newsgroups	gmane.network.net-snmp.user
Message-ID	<[email protected]>

Hello,

I would like to disable the traps that net-snmp sending when it starts.
This traps are:
/
*********************
enterprises.8072.4.0.2:
    CommunityString = ###
    Request = ###
    mib-2.1.3.0 = ###
    snmpModules.1.1.4.1.0 = enterprises.8072.4.0.2/
**********************

and this other

**********************
/snmpModules.1.1.5.1
    CommunityString = ###
    Request = ###
    mib-2.1.3.0 = ###
    snmpModules.1.1.4.1.0 = snmpModules.1.1.5.1
//    snmpModules.1.1.4.3.0 = enterprises.8072.3.2.10
*********************


/How can I disable only these traps, keeping /sink2/ definition in the 
snmpd.conf for sending after starting my own traps if it's necessary?

Thanks in advance,
Antonio.

/

/

-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users