Re: restarting snmpd does not generate a trap
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On 12/12/2007, PoWah Wong <[email protected]> wrote: > > snmptrapd -f -Le -Dsnmptrapd -d > > > > Then start up the snmpd agent again. > > What does the trap receiver display? > > > > > Now the trap receiver display: > # snmptrapd -f -Le -Dsnmptrapd -d > NET-SNMP version 5.4.1 > > Received 192 bytes from UDP: [172.20.11.245]:32832 [snip] So snmptrapd is at least receiving the raw packet. But if that is the *only* output, then the trap is being dropped before it gets as far as the trap processing. (Since almost the first thing that the trap receiver would do is log a debug message "input: 147") That means it must be the low-level receipt/parsing of the incoming trap that is failing. Two things to try: a) Run the trap receiver using snmptrapd -f -Le -Dusm -d This will show any problems in the SNMPv3/USM processing. b) Try sending the traps using '-l noAuthNoPriv' (and the same debug flags on the trap receiver side). Does this get any further? Dave ------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users