how snmp gets data from the hardware eg: NIC
chloe K <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
Hi all
I install snmp NET-SNMP version 5.4.1 in fedora 7
when I run mrtg to make .cfg file before. i saw the eth7 is in localhost_5
after rebooting, the eth7 is changed in localhost_2
but I don't have any hardwares and NIC configuration
it seems snmp recognizes the NIC7 was localhost_5 before
then snmp recognizes the NIC7 is localhost_2 now
why does it happen?
Thank you
---------------------------------
Looking for a X-Mas gift? Everybody needs a Flickr Pro Account!
-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services
for just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users