Re: How to deny access from only some hosts usinf vacm
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On 11/01/2008, arijit <[email protected]> wrote: > I think using the standard snmpd.conf configuration directives, I might still be > able to deny access to a particular community from a particular host or subnet. For particular *community* - yes, of course this is possible. But that only works for SNMPv1/2c. I stand by what I said earlier - you cannot do this for SNMPv3. And even for SNMPv1/2c, it isn't possible to do this through the VACM MIB interface alone. What you propose relies on the "com2sec" directive, which is a private Net-SNMP-specific config, outside the scope of the VACM MIBs. Dave ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users