Re: How to deny access from only some hosts usinf vacm
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On 14/01/2008, arijit <[email protected]> wrote: > What I was looking for was a way to specify a host ip address or a subnet ip > address - which, I can specify in the com2sec directive! You can specify the source host/subnet for SNMPv1/2c requests, as part of mapping the community to an internal security name. You can *not* specify a source host/subnet for SNMPv3 requests, because the SNMPv3 user is automatically mapped to the corresponding security name. There is no hook for providing source-specific mappings for SNMPv3 requests. We could argue for hours about whether this would be a good thing or a bad thing to support. But the bottom line is that the code does not include any such hook, so SNMPv3 requests are an all-or-nothing affair. Dave ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users