Re: upgrading from 5.2.3 to 5.2.4
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On 30/01/2008, Bell, Adam <[email protected]> wrote: > a) the output into snmpd.conf is from net-snmp-config, it looks the same > as it did for 5.2.3. net-snmp-config reports v5.2.4 "Looks the same" is a dangerous assumption. I suggested copying the file to another system, in case a non-printing character had crept in, or something similar. > b) I'll try your suggestions but I do not link in the UCD mibs, I posted > the net-snmp-config output to Thomas That's what is *meant* to be included in the agent, yes. I was suggesting you checked what was *actually* included in the agent - just in case the two were different. It might also be worth starting with a default build - make sure that behaves as expected. Then start pruning the configuration one chunk at a time, until you either get down to the desired fighting weight - or else you locate the source of the problem. Dave ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users