Re: Has anyone compiled net-snmp with dmalloc support recently?
Manfred Wassmann <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On Wed, 6 Feb 2008, Dave Shield wrote:
> I can confirm the same problem exists with both dmalloc 5.5.1 and dmalloc 5.4.3
> (running against both the current development code, and the 5.3.x line)
>
> I haven't had a chance to investigate further, but I suspect this may not
> necessarily be a recent problem.
Thank you for the note. I gave it another try and checked dmalloc version
5.4.2 and it did at indeed compile.
But it doesn't seem to work correctly, I can only run snmpd with "dmalloc
run", when I set "dmalloc low" snmpd segfaults just after being started
and anything higher leaves snmpd stuck. It doesn't even listen to a
SIGINT, only SIGQUIT shuts it down. But I'll keep trying...
Manfred
--
*** Message ends here ***
I am not responsible for anything below this line.
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users