Re: How to renew (update) data stored on a OID for a get request?

On 13/02/2008, Simon Huebner <[email protected]> wrote:
> is there no way to solve my problem with 5.2?

The cache helper is part of the 5.2.x distribution,
so you could probably use the cache-style framework
from the "mib2c.table_data.conf" template, with your
earlier "mib2c.create-data.conf" code.

Have a look at the init routine of the later code - that's
the sort of thing you'll need to add to the original MIB
implementation.   Then move the code for populating
the table into the "load" routine, and write a simple
"free" routine to drop this information.


  Or you could try with the "mib2c.table_data.conf"
template from the 5.2.x installation (which uses a
different though related table handler).
   Again, you'd need to insert the cache handling
code yourself - try comparing the results of

   mib2c -c mib2c.table_data.conf yourTable
and
   mib2c -S cache=1 -c mib2c.table_data.conf yourTable

(using the later mib2c config template).
That should show you the code you'll need to
add to the earlier template.



Dave

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users