reading MIB v1 with v2c request
Tomáš Macek <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
Hi, I'd like to know, if I can read mib v1 with the request version v2c or even v3. For example I'm able to read ifInOctets.1 like this snmpget -v1 -c community 192.168.0.1 ifInOctets.1 the same as with snmpget -v2c -c community 192.168.0.1 ifInOctets.1 so I'm able to read this with both the snmp v1 and v2c (it's for example a cisco router supporting snmp v2c) Is it rule due to the compatibility or is it only luck? I was not able found anything pointing me out of this. ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users