Re: problem trying to dynamically load modules

Thanks dave,

but I am wondering how can I use --ucd-snmp/dlmod?

In my case I have configured net-snmp.
Is that same option applicable for both net-snmp as well as ucd-snmp for
adding support of dynamically lodable modules

or should I go use  --net-snmp/dlmod

please correct me

San


On 2/20/08, Dave Shield <[email protected]> wrote:
>
> On 20/02/2008, san <[email protected]> wrote:
> >  But I don't see any options for turning on dynamically loadable support
> > when I run configure --help
>
>   --with-mib-modules=ucd-snmp/dlmod
>
>
> > I need options which enables dynamically loadable support for net snmp
>
> The simplest way to check whether dynamic loading is enabled or not,
> is to list the files under 'agent/mibgroup/ucd-snmp' after having compiled
> the agent.
>   If thefiles 'dlmod.o' and/or 'dlmod.lo'  exist (whatever you get
> from compiling
> the other modules), then dynamic loading is active.   If they don't exist,
> then it isn't.
>
> Dave
>

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/

_______________________________________________
Net-snmp-users mailing list
[email protected]
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users