Re: problem trying to dynamically load modules
"Dave Shield" <[email protected]>
| Newsgroups | gmane.network.net-snmp.user |
|---|---|
| Message-ID | <[email protected]> |
On 21/02/2008, san <[email protected]> wrote: > but I am wondering how can I use --ucd-snmp/dlmod? No - that's not what I said. The option is --with-mib-modules=ucd-snmp/dlmod This should probably be enabled as default. (but see below) > In my case I have configured net-snmp. Yes - that's what I assumed. The UCD-SNMP releases have effectively been dead for several years. The Net-SNMP project grew out of it, and much of the same code is still in use. > Is that same option applicable for both net-snmp as well as ucd-snmp for > adding support of dynamically lodable modules Yes. > or should I go use --net-snmp/dlmod No. > please correct me Could you please follow the instructions I sent yesterday: >> The simplest way to check whether dynamic loading is enabled >> or not, is to list the files under 'agent/mibgroup/ucd-snmp' after >> having compiled the agent. If you had bothered to do this, you would have seen that the module "ucd-snmp/dlmod" was valid for the Net-SNMP code as well. Dave ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Net-snmp-users mailing list [email protected] Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users